ASSEMBLY
1 Assembling the Lower Section to the Base Stand
Insert the connecting rods on the bottom of the Lower Section (A) into
the connecting holes on the middle of the Base Stand (E) then fasten
together at the connecting loops with the Bolt & WingNut (F).
2 Assembling the Middle Section to the Lower Section
Insert the connecting rods on the bottom of the Middle Section (B) into the
connecting holes on the top of the Lower Section (A) then fasten together
at the connecting loops with the Bolt & WingNuts (F).
3 Assembling the Upper Section to the Middle Section
Insert the connecting rods on the bottom of the Upper Section (C) into
the connecting holes on the top of the Middle Section (B) then fasten
together at the connecting loops with the Bolt & WingNuts (F).
4 Assembling the Light String & Branches
Insert the connecting rod at the end of each of the Lighting String &
Branches (D) into the connecting holes on the Upper Section of the Tree (C).
Note: It is recommended not to unravel the Light String & Branches until all
Branches are inserted into the Upper Section and plugged in.
5 Connecting the Light Strings
Connect the Lighting String and Branches (D) by inserting the connecting
pins on the end of the lighting string on branches into the receptacle holes
on the light cords attached to the Upper Section. Then press together
tightly for a secure fit.
6 Assembling the Branches
Unravel the Branches and let them fall naturally downward. Use the
diagram of the finished Tree on this Assembly Sheet as a reference to
best place the Branches on the Tree.
7 Assembling the Power Plug
Push two pins of lighting set near the base of the Tree into the end of
adaptor then screw down tightly until secure.
8 Assembling the Ground Stakes
Insert Ground Stakes (G) over the metal frame at 4 corners of the Base
Stand (E) (per diagram below) then firmly into the ground.
F
A
E
F
B
A
C
B
F
C
D
D
D
D
E
G
