2
CAUTION:
This appliance is not intended for use by persons (including children) whit reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Ⅳ
. How to install
Free standing installation:
First, take the heater out the package and place it upside down on soft
surface. Second, take four screws from the accessories(two screw for
each castor, parallel the bevel of castor bracket to the bevel of the heater,
if installed reversely, the screw cannot be revolved in.)and aim them at
the taps to tighten them. Third, Then just upright the heater and put it
into use. You may refer to the following figure.
OPERATION
Press ON/OFF startup to work in low mode, non-temperature setting state, the
temperature indicator is not on, and the ambient temperature is displayed.
Press the heating adjustment key to switch gears, switch between high and low, the
temperature indicator is off, and the ambient temperature is displayed.
Press the temperature setting button to set the temperature. The low-grade
controllable temperature ranges from 18
℃
to 24
℃
/ the high-grade controllable
temperature ranges from 25
℃
to 30
℃
. In the temperature setting state, when
switching between high and low grades, the corresponding setting temperature will
change (for example, the default setting temperature from low-grade to high-grade
is 25
℃
, and the default setting temperature from high-grade to low-grade is 18
℃
).
When the actual temperature is greater than the set temperature, turn off the
heating output; when the actual temperature is less than or equal to 2 degrees of
the set temperature, turn on the heating output; Whether it is low grade or high
grade, press 00 again after (low grade 24
℃
)/ (high grade 30
℃
) to cancel the setting
temperature, and the heating function continues to work. When setting the
temperature, the set temperature will be displayed for three seconds after setting
the temperature, and the temperature indicator will be on after three seconds, and
the ambient temperature will be displayed.
On time key, time 0.5h ~12H, each time press the key plus 0.5 hours, cycle
accumulates the end of the shutdown and beep; After setting 12 hours, press the
button again and the 000 display will disappear after 3 seconds. The timing is
cancelled and the timing indicator is off. When the timer shutdown function is
enabled, the timer indicator is steady on.
Remote control function, key operation (switch, temperature setting, timing,
heating adjustment); Same function as the four keys on the control panel.