4
USAGE
HEATER OPERATION:
Always operate the heater in the upright position following all
instructions and recommendations listed in this manual.
HEATER LOCATION:
Place the heater in the area of the room that is coldest.
HEATER CONNECTION:
Plug heater directly into 120 volt A.C., 60Hz wall outlet. Be
sure plug fits tightly in outlet. A loose connection may cause overheating and damage
to the plug or heater.
NOTE:
To prevent overloading a circuit, do not plug the heater into a circuit that is
servicing other electrical needs.
TURNING HEATER ON:
Make sure the Thermostat have rotate to MAX HIGH(+) position
For Flame Effect:
Slide Flame switch to ON position to have the flame effect.
For Low Heat:
Slide switch “I” to ON position.
For High Heat:
Slide both switch “I” and switch “II” to ON position.
Adjustable Thermostat
Flame switch, without heat
Switch I, Low Heat
Switch I + II combined, High Heat
Setting thermostat:
After heater has been turned on and the room has reached the
desired temperature, slowly rotate the thermostat knob counter-clockwise until the
heater shuts off (you should hear a faint “click”) By leaving the thermostat at the setting
it will automatically maintain this temperature. To lower the temperature, rotate the
knob further counter-clockwise towards the LOW(-) position. To raise the temperature,
rotate the thermostat knob clockwise towards the HIGH(+) position.
Turning off:
Turn the Main Power On/Off power switch OFF to discontinue use. The
Low Heat Switch and High Heat Switch can remain in any position and will have no
power. They will continue to have the same set functions when the heater is turned
back on. Heater should be unplugged when not in use.
CARE AND MAINTENANCE
CAUTION:
Before cleaning the heater be sure to disconnect power cord and allow the
heater to cool completely. Clean the outside surface with a clean damp cloth. Do not
use harsh chemical or abrasive cleaners.
DO NOT IMMERSE THE HEATER IN WATER.
Allow heater to dry completely before use. Use a vacuum or duster to keep heat and
vent area clean and free of dust and dirt.
REPAIR:
DO NOT OPERATE THE HEATGER WITHOUT THE GRILLE IN PLACE. DO NOT USE
THE HEATER IF IT HAS MALFUNCTIONED OR BECOME DAMAGED IN ANY WAY.
DO NOT REMOVE BACK COVER OF HEATER; NO SERVICEABLE PARTS.
Содержание 820-340V80
Страница 10: ...10...
