--Before inserting the plug into an electrical outlet, make sure that the electrical supply in
your area matches that on the rating label on the unit.
--When plugged in, turn on the Main power switch at the back of the unit.
a)
When in Standby mode, only the switch ON/OFF on the control panel will respond
to your touch, and the LED display shows the room temperature. Press ON/OFF to
access the rest of the control panel or remote control.Press it to the lower power,
press it again to turn off the heater.the unit will keep working 30 seconds of cool air
after turn off it . this design can protect item use longer.
b)
Low Power: (Press “POWER” to switch it)
c)
High Power: (Press “ POWER“to switch it)
d)
TIMER: Press ” TIMER ” button repeatedly to set a period after which the heater will
turn itself off (From 0 hour to 12 hours)
e)
+ , - : adjust room temperature .Temperature setting from 50-95
℉
degree. “+” to
increase the desired temperature and “-“ to decrease the desired temperature. (On
Remote control only)
f)
Osc : Press “ OSC “to activate oscillation. Press it again to cancel.
g)
Press ON/OFF to turn off the heater, the unit will keep working 30 seconds of cool
air after turn off it . this design can protect item use longer.
Warning: The heater will remain hot for some time after it is turned off; handle with
care.
REMOTE CONTROL
The remote control uses on button cell battery, type CR2025(3V).To remove the battery
carriage use your thumb to squeeze the release tab to the right and then pull the carriage
out. Place the battery into the carriage and slide the carriage back into the remote. See
Fig.1. We recommend the use of a Lithium-ion battery for longer use.
NOTE:
Follow battery
disposal instruction on battery packaging, or contact your local safety council for safely
disposal of batteries.
Before using the remote control, you must remove the insulating film as shown in the figure
below.
1. All functions performed with remote control work identically to the heater control
panel.(Except the temperature settings)
2. Aim the remote control at the heater control panel to operate the heater.
SPECIFICATION
Model No
820-250V80
Voltage
120V AC
Frequency
60Hz
Output Power (W)
1500W
OVERHEAT PROTECTION
This heater is protected with an overheat protection that switches off the appliance
automatically in case of overheat, e.g. due to the total or partial obstruction of the grids. In
this case, unplug the appliance, wait about 30 minutes for it to cool and remove the object
which is obstructing the grids. Then switch it back on as described above. The appliance
should operate normally. Should the problem persist, please contact the nearest customer
service.
TIP-OVER PROTECTION
This heater is protected with a safety switch that turns
off the appliance automatically when the heater falls
over, or is at an excessive angle from the horizontal.
This helps prevent accidents, and the heater will back
to the standby mode when it is put back upright, press
the buttons on control panel or remote control to reset
the heater