Holzstar 5922201, Руководство по эксплуатации

Страница: 13 / 20

Malfunctions, their potential causes and remedies
SAA Series | Version 1.06 13
10 Malfunctions, their potential causes
and remedies
11 Disposal, reusing used machines
To protect the environment make sure that all machine
components are exclusively disposed of as intended and
legally permitted.
11.1 Decommissioning
Disused machines must be decommissioned immedi
-
ately to prevent unintended use at a later point and put
-
ting the environment or persons at risk.
Step 1: Disposable environmental in hazardous opera
-
ting materials from the end of life device.
Step 2: If necessary, disassemble the machine into as
-
semblies and components that are easy to
handle and suitable for recycling.
Step 3: Dispose of the machine components and proces
-
sing materials using the intended disposal me
-
thods.
11.2 Disposal of electrical equipment
Electrical devices contain a variety of recycling-capable
materials and also environmentally hazardous compo
-
nents.
Separate these components and dispose of them appro
-
priately. In case of doubt, contact your local waste dispo
-
sal authority. Consult a specialist disposal agent for recy
-
cling if needed.
11.3 Disposing of lubricants
Lubricant manufacturers provide disposal information for
the lubricants used. If necessary, request productspeci
-
fic data sheets.
IMPORTANT!
If one of the following malfunctions occurs, immedi
-
ately stop working with the machine. Before you start
troubleshooting, turn off the machine and unplug the
power plug. Failure to do so can lead to serious
injury. All repairs or replacement work may be perfor
-
med by qualified and trained expert staff only.
Malfunc
-
tion
Possible cause Remedy
Machine
does not
start 1. Power plug is
not plugged in.
2. Power supply
cables defec
-
tive.
3. Switch defec
-
tive
4. Motor defective
1. Plug in the po
-
wer plug.
2./3./4.
Call a service
technician
Strong
vibrations 1. Loose compo
-
nent
2. Motor support is
brocked.
3. Motor bearing is
used up
1. Check all
connections,
tighten bolts
and nuts.
2. Replace the
motor support
3. Replace the
motor bearding
Poor
extraction 1. Dust container
is full
2. Filter is blocked
3. The Extraction
Unit is under-
sized
4. The extraction
line is too long
1. Empty the dust
container.
2. Clean the filter.
3. Use The ex
-
traction line
with Ø larger
than100 mm.
4. Set the Extrac
-
tion Unit near
on the wood
-
working
machine
NOTE!
Old chill lubricant emulsions and oils should not be
mixed with each other, because only not mixed waste
oils are usable without pretreatment.
ATTENTION!
Please take care for an environmentally sound dispo
-
sal of the used coolants and lubricants. Follow the
disposal tips of your municipal disposal companies.