Holzstar 5900790, Инструкция по эксплуатации, Страница: 10 / 20

10 KSO 790 | Version 3.02
Specification and standard equipment
7 Specification and standard
equipment
- Longitudinal and transverse table for mitres from 0
° to 45 ° steplessly swiveling
- Horizontally and vertically usable sanding unit, thus
wide Eisatzbereich vertical grinding possible
- With abrasive belt quick tension
- Standard with cross table for contour grinding, swi-
veling up to 45 °
- Longitudinal table is height-adjustable by 80 mm
for optimum utilization of the grinding belt width
- Including infinitely adjustable miter fence
- Graphite coating on the sanding sole for a higher
sliding property of the sanding belt and longer ser-
vice life
- With lockable emergency stop switch
- operating manual
- EU standard according to (CE mark)
8 Setting up and connection
8.1 Requirements for the installation
site
The Edge milling machine must be set up stable on a le-
vel and firm ground. It is important to ensure that there is
enough freedom of movement to work. On each side
there must be at least 1 m distance from the wall to the
edge sanding machine.
The site should meet the following criteria:
- The substrate must be level, firm and vibration-
free.
- The substrate must not let any lubricant through.
- The installation or work area must be dry and well
ventilated.
- Do not operate machines that cause dust and
chips near the machine.
- There must be sufficient space for the operating
personnel, for material transport as well as for ad-
justment and maintenance work.
- The site must have good lighting.
8.2 Setting up the edge milling ma-
chine
8.3 Electrical connection
When making electrical connections, make sure that the
characteristics (voltage, mains frequency, protection)
match those on the rating plate and for the engine.
Step 1: Check that the Edge milling machine is off.
Step 2: Connect the machine to the mains and check the
direction of motor rotation. 400 V machine: If the
direction of rotation is wrong, two phases must
be exchanged.
WARNING!
Do not use profiles in excess of the specification thick-
ness. Use the machine only for the intended purpose
ATTENTION!
Danger of injury due to a machine that is not stably
erected!
Check the stability of the machine after placing it on
stable ground.
CAUTION!
Pay attention to the weight of the machine!
The machine may only be set up by two persons.
Check the aid accordingly for sufficient dimensioning
and load capacity.
DANGER!
Danger to life due to electric shock!
There is danger to life when in contact with live com-
ponents. Switched on electrical components can
cause uncontrolled movements and lead to serious
injuries.
DANGER!
All work on the electrical installation may only be car-
ried out by a qualified electrician.