HOLZMANN MASCHINEN TFM610V, Руководство по эксплуатации

Страница: 31 / 39

HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 31
TFM610V
• Before each operation, check that the safety devices are in perfect condition.
• Check the connections for tightness at least once a week.
• Regularly check that the warning and safety labels on the machine are in perfect and
legible condition.
16.2.1 Tool exchange
C A U T I O N
Before any manual tool change, stop the spindles, wait for all tools to come to a
standstill and prevent unintentional restart.
16.3 Storage
N O T E
Improper storage can damage and destroy important machine parts. Store packed or
unpacked parts only under the intended ambient conditions!
In case of a longer interruption of operation or shutdown, clean the machine and then store it out
of the reach of children in a dry place protected from frost and other weather influences!
16.4 Disposal
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or equipment in residual waste. If necessary,
contact your local authorities for information on the disposal options
available. If you buy a new machine or an equivalent device from your
specialist retailer, he is obliged in certain countries to dispose of your old
machine properly.
Troubleshooting
W A R N I N G
Handling the machine with the power supply up can lead to serious injuries or even
death. Always disconnect the machine from the power supply before servicing or
maintenance work and secure it against unintentional or unauthorised reconnection!
Many possible sources of error can be excluded in advance if the machine is properly connected
to the mains. If you are unable to carry out necessary repairs properly and/or do not have the
required training, always consult a specialist to correct the problem!
Trouble Possible cause Solution
Machine cannot be switched on
No mains voltage available
•
- Carbon brushes worn out
Check power supply
•
Replace carbon brushes
The machine switches off
automatically during idling.
•
Mains failure
Check mains-side fuse
•
Due to undervoltage protection, the
machine does not restart
automatically and must be switched
on again after voltage recovery.
Machine stops during machining
overload protection activated due
to blunt tools or excessive feed or
chip thickness
Before continuing work, replace the
tool and wait for the motor to cool
down.
Speed drops during machining
Too much chip removal
Feed rate too high
•
Blunt tool
Reduce chip removal
Decrease feed rate
•
- Replace tool
Badly milling surface
Blunt tool
Uneven feed rate Replace tool
Work with reduce feed rate and constant
pressure
Dust collector port clogs
(without dust collection system)
Too much chip removal
Blunt tool
Too wet wood Reduce chip removal
Replace tool