OPERATION
HOLZMANN Maschinen Austria www.holzmann-maschinen.at
Seite 19
Luftschlauchaufroller / Retractable air hose wheel LSR 10HQ / 15HQ
15
OPERATION
If the
hose
can
be
rolled out
in full
length, not
huge
move on
, as
this may
tear
the
hose
and the
hose
-end
residual
dangerous
swirl around
15.1
Rolling out/ pulling the hose
Remove hose to the desired length and can withdraw slowly clicks into place.
If the hose reel does not lock the same again again go out and leave to withdraw slowly.
Repeat the process locked in the desired position until the hose reel.
If the hose is
released
during the
roll up
the hose end
to
uncontrolled
fast
take-up reel
.
Themselves and
other people can
thereby
be
injured
or
property
damaged.
Why
not let
the hose
when rolling
.
Always
lead to the
end of the hose
controlled
take-up reel
.
15.2
Rolling in / collect the hose
Further off hose is released to lock. Then slowly move the hose to the take-up reel.
15.3
Settings
15.3.1
Adjust tube length
The solid fixed length of hose with hose coupling can be set indefinitely.
Loosen the two cap screws on the hose-stop ring (1) carefully. Pull the tube out of the guide and
slide the hose-stop ring to the desired length.
Screw the two cylinder screws again
15.3.2
Change position of the guide arm
The position of the guide arm (9) is adjustable in 90° steps. Allows you to set parallel or angled
to the wall, floor or ceiling, the tube guide
By removing the 6 sided nut on the mounting and align the guide arm in the desired position.
the guide arm in position by tightening the 6 sided nut.
15.3.3
Adjusting the spring force
By adjusting the spring force of the return velocity of the tube can be adjusted individually. It
increases or reduces the effort to curl the hose off or on.
The air supply necessarily interrupt when adjustment, maintenance, and re-
pair work. Disconnect hose from the air supply!
ATTENTION:
Always hold the hose reel in this setting and do not let go!
