HOLZMANN MASCHINEN LP 700, Руководство пользователя

Страница: 19 / 26

MAINTENANCE
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at Seite 19
LP 700
10.2.1 Changing the tip
1. Wait until the tip and fixing nuts are well cooled.
2. Loosen the fixing nuts and remove the soldering tip.
3. Clean the heater and lightly lubricate with a thin film of oil.
4. Install a new tip and secure with the two nuts.
11 MAINTENANCE
A T T E N T I O N
During cleaning and maintenance with connected machine:
Property damage and serious injury from inadvertent switching on the
machine!
Therefore:
Switch the machine off and disconnect it from the power supply before any maintenance
works or cleaning is carried out
11.1 Cleaning
The full and regular cleaning of the machine ensures a long life and is a safety requirement. Use
only mild detergent, ie no gasoline, kerosene, soda etc ...
1. Always unplug the mains lead before cleaning.
2. Dry the soldering gun with a soft, lightly moistened cloth. Never use strong cleaning solutions
or solvents.
3. Make sure that no moisture gets into any of the soldering gun’s openings.
4. To clean the soldering tip thoroughly use a fine grade sandpaper to remove any oxides or other
contaminants on a regular basis or after about 20 hours of use.
Note: Never set the soldering gun to high during long periods as this can damage the
soldering tip.
11.2 Disposal
Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local
dealer for a replacement unit, the latter is obliged to exchange your old.