HOLZMANN MASCHINEN HBS245HQ, Руководство пользователя

Страница: 38 / 54

HOLZMANN MASCHINEN www.holzmann-maschinen.at Strana 38
PÁSOVÁ PILA / WOOD BANDSAW HBS245HQ
Upper blade guide (Fig.k; 3k)
The height of blade guide needs to be adjusted: prior to every cutting/operation, to accommodate
the height of work piece (the upper blade guide should be set approx. 3mm above the
workpiece).
 Set upper blade guide with the adjusting knob to the desired height by loosening the
locking knob (1k). After adjustment (2k), be sure to tighten the lock knob (1k).
 Loosen the knob (4k), and adjust bearing holder, so that guide bearing is positioned 1or
2mm from bottom of blade. Retighten the knob
 Loosen the knob (5k), and adjust trust bearing to a position of 0.5mm from rear of blade.
Retighten the knob (5k).
 Loosen the bolt (6k), and adjust guide bearing to a position 0.5mm away from blade.
Retighten the bolt (6k).
Lower blade guide (Fig.l )
The lower blade guide needs to be readjusted after every band saw blade change or tracking
adjustment.
 Loosen the socket bolt (1i), and move the entire lower blade guide, and adjust the guide
bearing to a position of 1 or 2 mm from bottom of blade. Retighten the socket bolt (1l).
 Loosen the bolt (2l), and adjust trust bearing to a position of 0.5mm from rear of blade.
Retighten the bolt (2l).
 Loosen the bolt (3l), and adjust guide bearing to a position 0.5mm away from blade.
Retighten the bolt (3l).
14.2.5 Cutting speed
N O T I C E
The cutting speed should be selected depending on the hardness of the
material to be machined.
hart: 400m/min weich: 800m/min
 Open the lower cover.
 Slacken driving belt by turning the knob clockwise.
 Put driving belt on required pulley of the driving wheel (lower band saw wheel) and the
corresponding motor pulley.