![Holux GR-90 Скачать руководство пользователя страница 18](http://html1.mh-extra.com/html/holux/gr-90/gr-90_user-manual_2147068018.webp)
GPS
Product series
With HOLUX, You never lose the way!
HOLUX Technology, Inc.
1F, No.30, R&D Road, Hsinchu 300, Taiwan (Hsinchu Science Industrial Park)
18
5.3.1
VCC_IN
This is the main DC power supply for a +3.3~ 5.5 V engine board.
5.3.2
BOOT_SEL
Pull high at power on stage for flash programming.
5.3.3
RF_ON
Indication of RF power staus. The pin will change in trickle power mode.
RF_ON is high when voltage is supplied to RF part of the chip.
5.3.4
V_ANT_IN
Power supply for active antenna. If 2.85V is used, this pin can be
connected to VCC_RF. For 5V active antenna, connect the DC power supply
respectively.
5.3.5
VCC_RF_O
2.85V DC power supply for active antenna.
5.3.6
V_BAT
Power supply to RTC and backup SRAM.
5.3.7
NRESET
Reset whole board. Active low.
5.3.8
TXA
This is the main transmitting channel and is used to output navigation and
measurement data for user written software
5.3.9
RXA
This is the main receiving channel and is used to receive software
commands to the board from user written software
5.3.10
RXB
This is the auxiliary receiving channel and is used to input differential
corrections to the board to enable DGPS navigation
5.3.11
GND
GND provides the ground for the board. Connect all grounds
5.3.12 1
PPS (GSC2x GPIO9)
This pin default is provides 1 microsecond pulse per second output from
the GR-90 which is synchronized to within 1 microsecond of GPS time. The
output is a CMOS 3V positive level signal. Only upon a situation of tracking or
navigating will output once per second. This is not available in Trickle-Power
mode.
5.3.13
LED_ONOFF (GSC2x GPIO14)
This pin can drive an LED. A 1K resistor must be connected. The LED will
flash in tracking mode.
TEL: 886-3-6687000 FAX:886-3-6687111 E-mail:[email protected] Website:www.holux.com.tw