-
26 -
Installing Speed Sensor
♦
The speed senor comes in two parts, the speed sensor itself and
the magnet. You can choose to install the speed sensor/magnet to
the fork/front wheel spoke or the chain stay/back wheel spoke of
your bike as long as the magnet is at the same level of the speed
sensor and the spacing of the two should not exceed 25
millimeters
♦
Use two cable ties to secure the speed sensor to the fork or chain
stay of your bike.
♦
Attach the magnet to the wheel spoke. The magnet must be facing
the speed sensor. For the spoke is too thin for the magnet to attach
by cable ties, users should tighten the magnet screw instead of
using cable ties.
♦
The magnet and speed sensor should pass facing each other with
no more than 25 millimeters between the two to transmit accurate
data.
Note: There is a power button on the surface of the speed sensor. Do
not push it unless you want to reset it for the GPSport 260 Pro to
re-scan it.
Содержание GPSPORT 260 PRO
