Programming the Essex Keypad
Note
: If the User ID, or User Code/PIN has not been assigned, you will hear one long beep
when # is entered.
Reset Keypad to Factory Defaults--- This is not normally necessary, but can be done as follows
STEP
ACTION BEEP Red LED
Green LED
1
The default Master Code is “123”
.
This can be changed to a unique code 3 - 8 digits long.
2
Enter
*3 1 2 3
#
Double Beep Slow Flash Solid
3
Enter
2
#
Double Beep Slow Flash
Slow Flash
4
Enter the desired activation time in
Seconds
followed by
#
Triple Beep Slow Flash
Solid
5
Enter
* *
to exit
6
Example:
2 # 10 #
* *
(10 second activation time)
Setting Main Relay Opening Time
STEP
ACTION BEEP Red LED
Green LED
1
Remove power
2
Jumper the “CONFIG” pins on the rear of the keypad
3
Apply 12 VDC power to red and black wires ONLY
Quadruple Beep Flash Solid
5
Enter
0 0 9 9
#
Double Beep Flash
3 Sec Flash
6
WAIT about 4 seconds
Quadruple Beep Flash Solid
7
Enter
9 9
#
Triple Beep Flash
Solid
8
Remove power
9
Remove “CONFIG” jumper
10
Reapply power
Page 11
Type 6.2.0.10-RF
