setting. Then adjust the set humidity by using the up and
down buttons. Humidity will increase in increments of 5%.
When the humidity level is set, the display will return to show
the current room humidity. When the room humidity level
rises above the set humidity, the humidifier will stop. When
the humidity level drops below the set humidity, the
humidifier will turn on automatically.
NOTE:
Allow up to 30 minutes for the filter to fully absorb
water and for the unit to produce moisture.
NOTE:
The AccuSet Plus
™
Humidifier has memory. This
means that when you turn the unit back on, it will be at the
last setting the humidifier was set at.
If you do not plan to use the humidifier for two or more days,
make sure any residual water is drained from the water tank,
base and wick filter to prevent algae or bacteria growth.
Extended Run Time Setting:
By setting your humidifier to a specific humidity level, you
are actually also extending the run time. Since the unit will
turn on and off to maintain the set humidity level, less water
will be used than on manual setting.
16 HOUR AUTO ON/OFF TIMER
INSTRUCTIONS
The Auto On/Off timer will allow the user two options, to
set a time to turn the unit off or to set a time to turn the
unit on.
Auto Off Timer
While the unit is running, the off timer can be activated by
holding down the up and down buttons simultaneously for
2 seconds, the screen will flash 00 and the up and down
arrows can be pushed to adjust the timer up to 16 hours in
increments of one, once 16 hours is reached, the next push
of the timer button will cycle back to 00 hours. The Timer
Light ( ) will illuminate when the Timer is set. The unit
will then shut off after the timer expires (in its current
setting). While the unit is running, the timer should stay on
even if other modes are being changed. The timer should
only be deactivated if the unit is turned off.
Auto On Timer
While the unit is off, the up and down buttons are pressed
simultaneously for 2 seconds and the display will flash 00
the up button may then be pushed again to increase the
hours to turn on (in its last setting) from 1-16 in
increments of 1 hour. The unit will then come on after the
timer expires, if the unit is then turned on, the timer will
be deactivated. The Timer Light ( ) will illuminate when
the Timer is set. Once 16 hours is reached, the next push
of the timer button will cycle back to 00 hours .
REPLACING THE FILTERS
Through normal use, waterborne minerals and sediment
become trapped in the wick filter. The harder your water, the
greater the amount of minerals in the water, and the more
often you will need to change your filter.
You will be able to monitor the life of the filter in your
humidifier by checking the FilterCheck
®
Indicator. When the
unit is off, the FilterCheck
®
Indicator will read in the OFF
position.
NOTE:
After 60 minutes of use, FilterCheck
®
Indicator will
move from the OFF position and
indicate your filter condition. A
brand new filter will register in the
section reading GOOD filter. After
frequent use of your humidifier,
the FilterCheck
®
Indicator will let
you know when the filters need to
be changed, see Figure 2.
When the needle is in the
CHANGE section, this means the
proper amount of moisture is not getting into your air
due to the excessive minerals and sediment that have
become trapped on your filters. At this point, you should
replace your filter. It is important to change your filter as
indicated to obtain stated performance level.
To replace the filter, follow the steps below:
1. Turn the unit off and disconnect from the electrical outlet.
2. Remove the tank and main housing to access the base tray.
3. Remove wick and discard.
4. Follow the weekly cleaning instructions.
5. Insert new filter.
6. Repeat Operating Instructions steps.
It will take about 30 minutes for the humidifier to reach
maximum output.
You can purchase replacement filters (model HWF65) at a
local retailer, by calling 1-800-546-5637, or by visiting
www.holmesproducts.com. It is recommended that a
replacement filter is purchased for uninterrupted use.
CLEANING AND MAINTENANCE
INSTRUCTIONS
Humidifiers provide comfort by adding moisture to dry,
heated indoor air. To benefit most from the humidifier and
avoid product misuse, follow all instructions carefully. Please
note that this is an electrical appliance and requires attention
when in use.
In addition, if you do not follow the recommended care and
maintenance guidelines, micro-organisms may be able to
grow in the water within the water tank. You must routinely
follow the cleaning procedures that follow in order to ensure
proper, efficient operation of your humidifier. Proper
maintenance and cleaning is essential to the continued
performance of your unit and the avoidance of algae or
bacteria build-up.
DAILY MAINTENANCE
1. Be sure the unit is OFF and is disconnected from the
electrical outlet.
2. Remove the housing and the tank from the humidifier
and place in sink or tub.
3. Carry the base of the unit to the sink, remove the wick,
place in sink, drain any remaining water and rinse
thoroughly to remove any sediment or dirt. Wipe clean,
and dry with a clean cloth or paper towel.
4. Drain the water from the tank into the sink and rinse
tank thoroughly. Wipe clean, and dry with a clean cloth
or paper towel.
5. Put filter back in, replace the housing, then refill tank
with cool tap water as instructed earlier in the Filling
Instructions. Do not overfill.
6. Follow Operating Instructions.
WEEKLY MAINTENANCE
To Remove Scale:
1. Repeat steps 1-4 above.
2. Clean the base by partially filling the base with one 8-oz
cups of undiluted white vinegar, or by using
Cleanse Clean
®
solution (Model S1710) by the
manufacturer. Leave this solution in the base for 20
minutes, while cleaning the all interior surfaces with a
soft brush. Remove base scale by wiping the base with a
cloth dampened with undiluted white vinegar.
3. Rinse with clean warm water to remove the cleaning
solution before disinfecting the tank.
To Disinfect Humidifier Base and Tank:
1. Fill humidifier base with 1/4 gallon of water and 1/2
teaspoon of chlorine bleach.
2. Fill the tank 1/2 full with water and 1/2 teaspoon of
chlorine bleach.
3. Let the solution stand for 20 minutes, swishing every few
minutes. Wet all surfaces.
4. Carefully empty the base and tank after 20 minutes, and
rinse with water until you cannot detect any bleach
smell. Dry with a clean cloth or paper towel.
5. Check the FilterCheck
®
Indicator to see if it is time to
replace the filter. Depending on water hardness in your
area, it may be necessary to change the filter every 1-2
months. Reinsert the wick filter into the base.
6. Refill the water tank as directed with cool tap water,
replace the humidifier housing, and turn the unit on.
PLEASE READ AND SAVE
THESE IMPORTANT SAFETY
INSTRUCTIONS
Consumer Safety Information
NOTE:
This is an electrical appliance and requires attention
when in use.
NOTE:
If moisture forms on the walls or windows of the
room, turn off the humidifier. The room already has plenty of
humidity and additional moisture may cause damage.
NOTE:
DO NOT block air inlet or outlet.
Cord and Plug Installation Safety Instructions
The length of cord used on this appliance was selected to reduce
the hazards of becoming tangled in, or tripping over a longer
cord. If a longer cord is necessary an approved extension cord
may be used. The electrical rating of the extension cord must be
equal to or greater than the rating of the humidifier (refer to
the rating artwork placed on the humidifier). Care must be
taken to arrange the extension cord so that it will not drape
over the countertop or tabletop where it can be pulled on by
children or accidentally tripped over.
HOW COOL MIST WORKS
Your Holmes
®
Cool Mist humidifier draws dry air through the
rear air intake grill area. This air is then passed through a
moisture–laden wick filter, which retains the minerals and
deposits in the water. The resulting moist air is directed back
into the room from the top air grill.
NOTE:
This humidification system provides a cool, invisible
moisture output. It is normal not to see the mist.
NOTE:
A humidity level below 20% can be unhealthy and
uncomfortable. The recommended humidity level is between
40%-50%.
PRE-OPERATING INSTRUCTIONS
1. Be sure the humidifier is switched to OFF and the unit is
disconnected from the electrical outlet.
2. Select a location for your humidifier, on a flat surface,
about 4 inches (10 cm) away from the wall. DO NOT
place the humidifier on a finished floor or near
furniture, which can be damaged by moisture or water.
Place on a moisture-resistant surface.
FILLING THE WATER TANK
1. Remove the tank from the base of the humidifier and
bring to the faucet. Turn the tank upside down and twist
off the tank cap by turning counter clockwise. Fill tank
with cool, fresh tap water. DO NOT fill with warm water
as this may cause leaking. Replace the cap on tank
FIRMLY.
2. When full, carry tank to the humidifier and place onto
the base. The tank holds 2.25 gallons of water and the
base holds 1/4 gallons of water. The tank will
immediately begin to empty into base.
3. Plug the power cord into a 120V AC electrical outlet.
OPERATING INSTRUCTIONS
Your humidifier is equipped with a technologically advanced
AccuSet Plus
™
digital Humidistat. You can set the humidifier
to run continuously in manual mode or set the AccuSet Plus
™
digital Humidistat to your desired humidity setting. The
AccuSet Plus
™
digital Humidistat will automatically turn the
humidifier ON or OFF, depending on the preset comfort level.
The comfort level ranges between 35% and 65% relative
humidity.
Manual Mode Instructions:
1. Plug the humidifier into a 120V AC electrical outlet.
2. The display will show the current room humidity.
NOTE:
The display range is 21% - 90%. If your room
humidity level falls below 21%, the unit will display 21. If
your room humidity level rises above 90%, the unit will
display 90.
3. To start the unit, push the MODE (
) button twice
within 3 seconds for the HIGH (3) manual setting.
4. Press the (
) button again for the MEDIUM (2) manual
setting and again for LOW (1). After the selection is made,
the display will return to show the current room humidity.
5. To stop the unit, press and hold the (
) button for two
seconds, or keep pressing the button until the display
reads OFF (OF).
AccuSet Plus™ HUMIDISTAT INSTRUCTIONS
To take advantage of the AccuSet Plus
™
Digital Humidistat,
press the MODE (
) button until the speed is set in either
the auto HIGH (A3), auto MEDIUM (A2) or auto LOW (A1)
P L E A S E R E A D A N D S AV E T H E S E
I M P O R TA N T S A F E T Y I N S T R U C T I O N S
F E AT U R E S - O P E R AT I O N S
1. Read all instructions before using the appliance.
2. To avoid fire or shock hazard, plug the appliance directly
into a 120V AC electrical outlet.
3. Keep the cord out of heavy traffic areas. To avoid fire
hazard, NEVER put the cord under rugs or near heat
registers.
4. DO NOT place humidifier near heat sources such as
stoves, radiators, and heaters. DO locate your humidifier
on an inside wall near an electrical outlet. The humidifier
should be at least 4 inches (10 cm) away from the wall
for best results.
5. NEVER place humidifier in an area where it is accessible to
children. NEVER use humidifier in a closed room, particularly
where a child may be sleeping, resting, or playing (a closed
room may result in excessive humidity).
6.
WARNING:
Do not attempt to refill humidifier without
first unplugging the unit from its electrical outlet. Failure to
heed this warning may cause personal injury. Be sure to
unplug the unit by pulling on the plug and not the cord.
7. Never place anything over moisture outlet when the unit
is running.
8. NEVER drop or insert any object into any openings.
9. DO NOT operate any appliance with a damaged cord or
plug, after the appliance malfunctions, or if it has been
dropped or damaged in any manner. Return appliance
to manufacturer for examination, electrical or
mechanical adjustment, or repair.
10. Use appliance only for intended household use as described
in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or injury to
persons. The use of attachments not recommended or sold
by the manufacturer may cause hazards.
11. DO NOT use outdoors.
12. Always place humidifier on a firm, flat, level surface. A
waterproof mat or pad is recommended for use under the
humidifier. NEVER place it on a rug or carpet, or on a finished
floor that may be damaged by exposure to water or moisture.
13. DO NOT allow the Moisture Outlet to directly face the wall.
Moisture could cause damage, particularly to wall paper.
14. Humidifier should be unplugged when not in use.
15. NEVER tilt, move, or attempt to empty unit while it is
operating. Shut off and unplug before removing the
water tank and moving the unit.
16. This humidifier requires daily and weekly maintenance
to operate appropriately. Refer to daily and weekly
cleaning procedures. Use only cleaners and additives
recommended by the manufacturer.
17. NEVER use detergents, gasoline, glass cleaner, furniture
polish, paint thinner, or other household solvents to
clean any part of the humidifier.
18. Excessive humidity in a room can cause water
condensation on windows and some furniture. If this
happens, turn the humidifier OFF.
19. Do not use humidifier in an area where humidity level is
in excess of 50%. Use a hygrometer, available at your
local retailer or through the manufacturer, to measure
the humidity.
20. DO NOT attempt to repair or adjust any electrical or
mechanical functions on this unit. Doing so will void
your warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed by
qualified personnel only.
21. Never place housing under water flow or immerse in
liquids.
22. Do not plug in the cord with wet hands: electric shock
could result.
23. Do not pour water in any openings other than the water
tank.
24. To prevent damage to surfaces, do not place humidifier
under overhanging surfaces.
25. NEVER operate unit without water in the tank.
26. Do not move unit after it has been used until unit cools
completely.
27. Use both hands when carrying full tank of water.
F E AT U R E S - O P E R AT I O N S
C L E A N I N G / M A I N T E N A N C E
I N S T R U C T I O N S
THIS APPLIANCE HAS A POLARIZED PLUG (one blade is wider than the
other). To reduce the risk of electric shock, this plug is intended to fit in a
polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to
install the proper outlet.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS
SAFETY FEATURE IN ANY WAY.
Figure 1
A. Water Tank
B. Carry Handle
C. FilterCheck
®
Indicator
D. Humidifier Housing
E. Control Panel
F. Humidifier Base
D
B
A
E
F
C
Figure 2
HM1865-U_08EM1.qxd:9100030005310 5/15/08 11:32 AM Page 2
