5 of 8
Spray Arms
Adjusting the Angle of the Spray Arms:
Adjusting the angle of the
Spray Arms
allow you to control the spray distance
For maximum coverage, turn the tips upwards
and out to approximately a 30º angle
For minimum coverage, turn the tips slightly downward
and clear of the
Travelling Sprinkler
body
Setting up the Hose Track
The
Front Wheel
of the
Travelling Sprinkler
is designed to be placed over top of the hose and
then track the same path as the hose. On some
surfaces the wheel may be prone to veering off the
hose. Users should keep an eye on this when first
operating the
Travelling Sprinkler
. If the surface is
unsuitable, causing the
Front Wheel
to veer from the
hose, it may be necessary to use an 18mm hose
The
Travelling Sprinkler
comes with both
12mm
and
18mm Snap-on Hose Connectors
Up to 60 metres of hose can be used to lay
out a path throughout the yard. To create 180º
turns, a minimum radius of 4.5m is required
Place the
Shut Off Ramp
on the hose to stop the
Travelling Sprinkler
. There should be 1.5m of
straight hose on either side of the
Shut Off Ramp
.
Be sure to anchor the
Shut Off Ramp
into
the ground with the attached spike
Please ensure the
Stop Pin
is pulled all of the way
out on the underside of the
Travelling Sprinkler
.
This pin will stop the
Travelling Sprinkler
from
moving, but will not stop the watering
* For more information, refer page 6
Speed Control
Depending on the speed selected, the
Travelling Sprinkler
can travel from 6 to 11
metres per hour.
LOW
will apply more water,
with
HIGH
preferred for lighter watering
To water a specific area and to keep
the
Travelling Sprinkler
stationary,
set the control to
NEUTRAL
Installation and Setup
(continued)