GENERAL OPERATOR’S MANUAL
BLIMPIE CONVEYOR TOASTERS
MODEL QCS3-950HB
PAGE 8
MAINTENANCE PROCEDURES CONT.
B. REPLACING FAN MOTOR
1)
DISCONNECT UNIT FROM POWER SOURCE.
2) Remove screws from the enclosure and the back panel at rear of unit.
3) Remove the enclosure and the back panel.
4) Unplug power supply cord from fan motor.
5) Remove (4) screws, which hold fan motor and grill to bottom of unit.
6) Put replacement motor and grill in place and secure to the bottom of unit with screws.
7) Reconnect power supply cord to fan motor.
8) Replace back panel and enclosure. Fasten with screws removed in step 2.
C. REPLACING BELT DRIVE MOTOR
1)
DISCONNECT UNIT FROM POWER SOURCE.
2) Remove enclosure and back panel.
3) Remove sprocket from motor shaft.
4) Remove the wire from terminal block connecting the drive motor to internal wiring. On units rated
208 or 240 volts, note which color leads are being used for these connections and which lead is
capped with white tape. The new motor should use the same arrangement.
5) Remove screws holding motor in place.
6) Put new motor in place and attach loosely with mounting screws.
7) Replace sprocket on motor shaft.
8) Slide motor until the drive chain has about 1/8" slack when lightly pushed at the center of its top
open run.
9) Tighten screws to secure motor.
10) Rewire leads same as removed in step 4.
11) Replace side panel and control box cover.
IF ASSISTANCE IS REQUIRED FOR THIS OR ANY OTHER PROCEDURE IN THIS MANUAL CALL THE
HOLMAN COOKING EQUIPMENT FACTORY SERVICE TEAM at 1-800-807-9054 24 HOURS/DAY 7
DAYS/WEEK
