8
CLEANING
Preventive maintenance for your Holman toaster consists of the following recommended
cleaning procedures. To keep your toaster in its top operating condition, these steps should
be performed on a daily or weekly as indicated.
A.
Clean air intake on the front of the unit using a damp cloth. (Daily)
B.
Conveyor Belt
"Turn the heat controls to the OFF position"
• Using a nut driver, remove the two acorn nuts and washers from each side of the load
up trays. Clean trays using mild detergent.
• For units with power saver switch only, turn the unit on and advance the conveyor belt
to the next section and wipe the belt. Repeat until the entire belt has been cleaned.
• For units with individual heat controls, turn the unit to FULL POWER and turn the heat
controls to the OFF position. Set the conveyor belt speed to the maximum speed and
wipe the conveyor belt with a damp cloth as it turns.
• For heavily soiled conveyors, turn conveyor speed control to fastest setting and wipe
with a light abrasive pad (as needed).
C.
Turn main power saver switch to the OFF position. Disconnect unit from power source.
D.
After the unit cools, remove interior crumb tray (as shown on page 5) and clean.
Slide crumb tray back into position.
E.
Wipe exterior surface of unit, using damp cloth and mild detergent.
WARNING
DO NOT IMMERSE OR LET THE UNIT STAND IN WATER.
DO NOT HOSE DOWN THE UNIT OR THE TABLE/COUNTER IF THE UNIT IS ON
THE TABLE/COUNTER.
KEEP AWAY FROM RUNNING WATER.
