Holman 314HX Series, Инструкции по сборке, установке и эксплуатации

Страница: 9 / 28

CLEANING CONTINUED
MONTHLY
1. Turn main power switch to the OFF position. Disconnect unit from power source and allow to
cool.
2. Perform daily & weekly cleaning procedures.
REMOVAL & CLEANING CONVEYOR BELT
3. Heavily soiled conveyor surfaces, locate the Master
Links on the conveyor belt. Follow the step 1 in Fig 1, to
remove all of the Master Links. 314 models have 3 master
links, 318 models have 4 master links.
4. Now that the links have been un-hooked, the conveyor can
now be carefully removed from the oven. Standing at one end
of the oven. Starting with the end on the bottom, roll the
conveyor belt until it has been totally removed. Take careful
notice being sure not to damage the heater tubes.
5. Clean conveyor belt in deep sink, caustic cleaners may be
used. For a heavy soiled conveyor belt, soak over night in hot soapy water.
NOTE: DO NOT ATTEMPT TO CLEAN THE HEATER TUBES.
6. Take this opportunity to
clean and remove any
loose materials inside the
unit. Using a mild cleaner
and damp cloth, carefully
wipe the inside surfaces
being sure NOT to clean
the heater tubes. DAMAGE
CAN OCCUR TO THE
HEATER TUBES FROM
IMPROPER CLEANING.
DO NOT SPRAY
CLEANING SOLUTIONS
INTO OVEN CAVITY.
7. Remove the conveyor
support system as shown
in Fig 2. by removing the
Couplers from the mounting Studs. Clean by warm water and abrasive pad.
8. Reinstall the conveyor support system.
9. Reinstall conveyor belt by first laying the belt along the bottom of the oven cavity making
sure the hooks on the sides are facing the inside and the ends of the hooks will be
pointing away form the direction of the belt so not to catch on any internal components
once put back into operation.
NOTE: THE DIRECTION OF THE BELT.
10. Next, pull one end of the conveyor belt over the top of the sprockets, (being sure to line the links
up properly with the sprockets) bringing the two ends together.
11. Reinstall the previously removed master links as shown in steps 2 & 3 in Fig. 1.
12. Examine the oven to assure proper installation, once satisfied, install crumb trays if you
have not done so.
13. Reconnect oven to power supply and check for proper operation.
IF ASSISTANCE IS REQUIRED, CALL THE STAR SERVICE TEAM AT (314) 634-6303.
1.
2.
3.
IL1021
MOUNTING STUD
COUPLER
BELT SUPPORT ROD
IL1022
CAUTION