Step 4: Installing extension
assembly on 4 bike model.
Slide extension assembly
B1
into
base assembly
B
per Fig. 11. Align
holes and insert bolts through the
walls of the tubes (Fig.11b). The
square holes in the inner tube will
prevent the bolts from spinning, and
the bolt heads should be almost flush
with the outer tube. Install flat
washers, then lock washers and nuts
per Fig. 11c. Tighten nuts securely.
Repeat Steps 3 and 4 for installing
the wheel holders and frame hooks.
Note: The front square reflector cap
is attached with a Phillips head screw
below it, and should be mounted in
either the 2 bike or 4 bike
configuration.
Fig. 11
Fold up feature:
To fold up the main beam,
You must first fold down the
vertical post. Refer to Fig. 12:
Rotate and remove pin B, then
rotate the post (B) and replace
the pin in either holes C.
Now refer to Fig. 5: remove clip
R
from pin
H6
, then remove pin
H6
. Rotate main beam upward
and re-install pin and clip. See
Fig. 13a and 13b
Tilt
–Down Feature:
For easy access to the rear
cargo door of your vehicle,
the Sport Rider can be tilted
down: First fold down vertical
Post as described in “Fold-up
feature”. Next refer to fig. 5:
Remove pin
H5
from receiver
tube bracket and gently lower
the main beam down so it is
resting on the welded stop.
See Fig. 14
Fig. 11a
Fig. 11b
Fig. 11c
Fig. 12
Fig. 13a
Fig. 13b
4
Fig. 14
