Page 4
If you prefer to hang this product horizontally, please follow
instructions below.
Note: No drilled hole or plastic anchor required when
mounting to stud or wood wall. Use screw only. We do
not supply hardware for mounting on concrete walls.
Figure 3
Find a desired location. Mark 2
locations for screws on wall in the
same distance as the mounting
holes on the back of the unit.
One screw (for each unit) must be
attached directly into a wall stud.
Wall anchor is not needed when
mounting to wall stud.
Drill one of the markings with a
3/16" drill bit (for each unit).
Insert Plastic Anchors (1) into the
hole on wall as shown. (When
doing this, you will need a
hammer help you).
Using the Phillips head
screwdriver, install Screw (2) into
the Anchor (1). Turn the Screw (2)
until there is a gap of
approximately 3mm between the
head of the screw and the wall as
shown.
Figure 4
Hang the Wagars Mirror onto the
Screw (2) and verify the mirror is
resting securely on the mounting
Screw (2).
Now your Wagars mirror is ready
to use.
Option 3
Third Direction
