Holland Green Science Boreas Pagoma 10308002, Руководство пользователя

Страница: 16 / 36

User Manual
Version 1.0 16
8.1 Installation Warning
Allow
the unit to sit upright for 24 hours before starting up.
8.2 Location
When the freezer is in position, set the front caster brakes.
The freezer must not be moved with product loaded inside.
Note:
For proper ventilation and airflow, a minimum clearance of 12cm at the rear and top
and a clearance of 20cm on the side of the freezer is required. Allow adequate space
in the front of the freezer for door opening. Locate the freezer on a firm, level surface in
an area with an ambient temperature between 18°C and 32°C.
Provide ample room to reach the mains disconnect switch (power switch) located on the
rear of the freezer.
8.3 Install Wall Bumpers
Open the right bottom door, take out the key and open the outer door of the freezer.
The parts bag, located inside the cabinet, contains the following parts.
Use M4X10 countersunk head screw and M4 washers to install the positioning bracket
into the pre-drilled hole behind the base of the unit (See Figure 1-2 for the location of the
hole)
，
install the screw cap on each screw, as shown in Figure 1-7.