1.
2.
3.
4.
5.
6.
7.
Fit your cutter into the drill arbor and tighten both grubs screws using the hex wrench provided onto the 2 flat
sections of the cutter.
Fill coolant reservoir with a water-soluble coolant.
Position the Holemaker on the work piece with the pilot pin over the centre of the hole to be cut.
Lower cutter/drill to surface of material. coolant flow starts when pilot pin is depressed.
Lifting pilot pin off work surface will stop coolant flow.
Move the rocker switch ( magnet switch ) located on the panel to the ON position. The switch will illuminate
to indicate DC power is going to the magnet.
Depress motor ON switch to start drill.
To start a cut, apply pressure until the cutter has establised an external grove. Then apply steady pressure
through the remainder of the cut (Note: Do not peck drill when using annular cutters). The tools are designed
to evacuate chips when drilling.
AFTER THE CUT
1.
After the cut has finished, the slug should be expelled on the down stroke. If the slug is not expelled after the
cut, disconnect the machine from the power source and remove the cutter from the arbor body, then expel the
slug. (Caution: The pilot should not be used to do this).
After the cut is finished, return the cutter back through the hole to the original position, depress motor OFF
button and wait until motor fully stops. Move magnet switch to the OFF position to release the magnetic
base from the material.
2.
READY TO MAKE THE CUT
7
