-
４
-
Getting Started
This chapter will help you get started.
It describes the basic functions of the meter.
Front Panel
①
AC/DC &
switch
②
Hold switch
③
MAX/MIN switch
④
PEAK HOLD switch
⑤
Back Light switch
⑥
RANGE & STROKE 4/2(DIS) & #CYL TRI
G± & DC OUTPUT/
Square
wave output
⑦
Function/Range switch: Turn this switch to select a function or turn the
meter OFF.
⑧
Safety protector
9)Test lead terminal: The Black test lead is used in the Com terminal for all
test . The red test lead is used to measure Amps or Volts
temperature Terminal: insert the temperature probe in this terminal.
Function and e select
Turn the rotary switch in either direction to select a function.
The range is automatically selected by the meter. But you can also select a
range within a function by pressing by pressing the range button.
Always select a range higher than you expect the function . then select a lower
range if better accuracy is needed
*if the range is too high ,the reading are less accurate.
*if the range is too low ,the meter shows OL(over limit)
Push-button Functions
DC/AC
BUTTON
Press this button to select the following functions:
DC/AC Voltage & Current Diode/Continuity.
RANGE & Stroke 4/2(DIS)
#CYL TRIGGER
±
BUTTON
Press this button to select:
RPM ×10RPM position STROKE 4 2 DIS
DWELL position 4CYL 5CYL 6CYL 8CYL
ms-PULSE %DUTY position TRIGGGER-
Signal Output DC output /
Square wave output
V/A Resistance position Manual Range
MANUAL RANGING
The meter turns on in the autoranging mode. Press the Range button to go to
manual ranging. The display icon "
" will appear. Each press of the range
button will step to the next range as indicated by the units and decimal point
location. Press and hold the Range button for two seconds
to return to
autoranging
.
NOTE:
*If the range is too high .the readings are less aceurate.
*If the range is too low . the meter shows
OL
(over limit)
Date Hold
The
Date Hold
feature stores the last reading in memory
*Press the
HOLD
button once to hold the present reading.
*Press the
HOLD
button again to exit and resume readings.
max/min button
Press the MAX/MIN button to activate the MAX/MIN recording mode. The
display icon "MAX or MIN" will appear. The meter will go to manual ranging &
display and hold the maximum or minimum reading and will update only when a
