Hokkaido HWMI 150 A, Инструкция по установке и эксплуатации

Страница: 8 / 28

- 8 -
INSTALLATION
•
•
•
•
•
•
•
•
Enough space must be kept for easy installation
and maintenance.
The air inlet and outlet must be free from obstacles
and strong wind.
The bearing surface should be flat and able to bear
the weight of the Unit. It must not increase noise or
vibration.
•
•
•
Precautions before installation
•
Installation space
Decide the correct way of conveying the equipment.
If the Unit has to be installed in a metal part of the
building, electric insulation must be carried out, and
the installation must meet the relevant technical
standards for electric devices.
•
Before installing the Unit, reserve the space for
maintenance shown in the following Figures.
The operation noise and air flow expelled shall not
affect neighbours.
The appliance must not be installed in places where
flammable gas may leak.
Installation location must be convenient for piping and
wiring.
If the appliance is installed in indoor space, it might
cause a temperature drop and noise disturbance.
Please take preventive measures for this.
If the Unit needs to be installed on a metal holder, make
sure they are insulated well and in accordance with
local standards.
Installing the equipment in any of the following places
may lead to malfunctions of the equipment itself (if it
is inevitable, consult the Supplier).
INSTALLATION LOCATION 3.
CAUTION
•
The site contains mineral oils such as cutting lubricant.
•
Seaside, where the air contains much salt.
•
Sites where there are corrosive gases.
•
Factories where the power voltage fluctuates seriously.
•
Inside a car or cabin.
•
Place like kitchen where oil permeates.
•
Place where strong electromagnetic waves exist.
•
Place where flammable gases or materials exist.
•
Place where acid or alkali gases evaporate.
•
Other special environments.
•
Display
Air outlet
Barrier
600mm
800mm
200mm
600mm
500mm
200mm
Fig. 3-1
Fig. 3-2