TWEETER POD
INSTALLATION INSTRUCTIONS
3
TECH SPECS
TECH SPECS
Power Handling ............................... 50 RMS / 100 Peak
Frequency Response ......................... 3hz-25Khz
Front. Speaker Sensitivity .................. 92 db 1watt/1meter
Nominal Impedance ......................... 6 Ohms
Passive Network .............................. 5k-3rd Order Butterworth
Suitable for 2-8 ohm Radios or Amplifiers
TECH SPECS
Step #3: With the tweeter pod in hand, move to the seat side of the bike, and run
the speaker wires through the bottom 5/16” (8mm) holes just drilled.
This kit comes with “see through” grills installed, and a second set
covered with grill cloth. To change grills, remove the 2 screws
holding the small circuit board in place on the back side of the pod,
and straighten up the 4 folded over “legs” Once straight, pushing on
each leg will allow the grill to release from the pod. Sit the new grill in
place making sure it is fully “seated” and fold the legs over to secure.
Re-install the circuit board.
Step #4: Holding the tweeter pod in place, locate the mounting screws with
washers and install them through the upper holes,
making sure
the tweeter’s wires do not get pinched as the pod gets
secured to the fairing
. Make them snug, but do not over tighten.
DO NOT USE “SCREW GLUE” OF ANY KIND
as it eats plastic.
The supplied mounting hardware and hole size allow room for minor
adjustments, so before the part is completely secured into place, make
sure it is lined up where you want it. If you are replacing a HD Fairing
Dash Pad (HD Part # 58262-05) you need to use their washers which
are larger diameter than the supplied washers. You may want to start
the bike to check for rattles. If anything is rattling, use the supplied loose
piece of foam to “shim” the pod and stop any rattles.
Step #5: Unplug the 2 speaker wires on the brake side front fairing speaker.
Using a “Y” cable that came in the kit, plug the 2 larger male
connectors of the “Y” jack into the female connectors that were just
unplugged at the speaker noting they will only go in one way. The
female connectors on the “Y jack will now plug into the front fairing
speakers-again, they will only go on one way. Plug the 2 wires with
smaller male spades on the brake side tweeter into the 2 remaining
connectors on the “Y” Jack. Repeat for the clutch side.
Step #6: Re-install the battery ground wire, turn your radio on and confirm that
both speakers and both tweeters are playing. You can adjust the
tweeters sound using the treble control on your radio. Re-install your
outer fairing and your new speakers are ready to enjoy!
Содержание HF-1 HOG POD
Страница 1: ......
