Hoggi SWINGBO-VTi, Инструкция по эксплуатации

Страница: 17 / 39

17
After the front screw connections have been loosened, the rear screw
connections must be found.
Due to the design of the SWINGBO VTi and the individual seat height
settings, the rear screw connections are not always directly visible.
In this case, the seat unit may have to be moved to a different seat
angle position in order to make the screw connection between the
oblong holes visible.
Here it is also possible to work through the hole on the pressure plate
with a 4 mm Allen key.
The seat plate can then be moved forwards and backwards.
6.3 Active degree
The active degree describes the ratio of the position of the backrest
relative to the drive wheel axis. The further the backrest is set behind
the the drive wheel axle, the more active SWINGBO VTi can be driven.
SWINGBO VTi offers a total active degree adjustment range of 10 cm.
Setting active degree 0 - 5 cm:
If the pressure plate is attached to the base plate as shown, moving the
seat unit results in an adjustment range of 0 - 5 cm.
Setting active degree 6 - 10 cm:
If a larger active degree range is to be set, both pressure plates must
be loosened and removed.
Then the plates are exchanged from the left side of the chair to the right
and vice versa.
The resulting attachment is shown in the picture.
0 - 10 cm
6.4 Back height
First of all, a distinction must be made between a trough-shaped back
-
rest and an angle-adjustable backrest.