Display Settings
You may adjust the LCD brightness of the ergoFET by doing the following:
1. Set the unit in the display mode by holding down the Threshold button and click the Reset Button twice.
2. Once the unit is in the display mode, press and hold the Threshold button until the desired brightness level is
achieved. Display will go from dim to bright and then recycle through.
3. Press the Reset button to return to test mode.
Force Measurement Settings
You may choose the unit of measure, (lbs, Newtons, KGF) by putting the ergoFET in the Force Measurement
mode press and hold the Threshold button for five seconds, the display will go blank only showing hash mark
for the unit of measurement currently chosen. Press the Threshold button to toggle through options. Press the
Reset button to return to test mode. Refer to Image C.
Image C
Wireless Mode - Power On/Off
To turn on or set the ergoFET to RF mode for use with software:
1. Hold the threshold button down for 5 seconds for the force measurement setting mode.
2. Continue to hold the threshold button down for another 5 seconds to turn on the wireless power.
3. The Peak Force display will show RF (wireless), and the Duration/Secs display will show on or Off.
4. Press the threshold button to toggle the RF (wireless) power on or off. Toggle on for use with software.
Refer to Image D for RF and On/Off display for wireless mode.
Image D
Page 8
