20
Adres producenta/ Adresse des Herstellers/ Manufacturer’s Address/ Адрес производителя
GTV Poland Sp. z o.o. Sp. k., ul. Przejazdowa 21, 05-800 Pruszków
KEY PARTS DIAGRAM
4: Square drive head
2: Direction of rotation knob
3: Trigger
1: Air inlet
IMPORTANT INFORMATION
General usage description
The air-powered impact wrench features Impact of job security, free from vibration, heat, electromagnetic, etc, segmented in take
structure design, handing more accurate. tool has the appearance of new, large torque, low noise characteristics. knob to change the
structure, the pros and cons easily manipulated, high alloy steel, ensuring a more durable wear, greatly extend the service life. Best
used for tire rotation, brake repairs, exhaust repairs, mechanical equipment bolt etc.
Compatible compressor and air tool:
GUIDELINES FOR PROPER USAGE AND POERATION
Always ensure the use of appropriately matched air tools and compressors. The compressor should be able to supply a minimal air
delivery of 3 SCFM@90PSI to ensure the compressor can run continuously with the DOTOOL Air-Powered Impact wrench. Using tools
or a combination of tools that together or separately require air pressure more than that of which the air compressor can deliver will
reduce performance and could void the compressor or tool guarantee/warranty.
Air compressor
size & power
2HP
2-1/2 HP
3+ HP
19-23 liters
Light duty and intermittent use
Light duty and intermittent use
Medium duty and intermittent use
30-42 liters
Light duty and intermittent use
Medium duty and intermittent use Heavy duty and continuous use
57+ liters
Medium duty and intermittent
use
Heavy duty and continuous use
Heavy duty and continuous use
AIR SYSTEM
Always use clean, dry, regulated, compressed air at 4 to 7bar (60 to 100PSI).
Do not exceed the maximum and minimum pressure. Operating the tool at the wrong pressure (too low or too high) will cause
excessive noise or rapid wear.
It is recommended that a filter-regulator-lubricator be used and be located as close to the tool as possible.
If a filter-regulator-lubricator is not installed, place up to 6 drops of pneumatic tool oil into the air inlet plug before each use.
If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty filter will reduce the air pressure to the tool, which
will cause a reduction in power, efficiency, and general performance.
