Hog Technologies HT1000SR, Руководство по эксплуатации

Страница: 43 / 90

43
Section 4 - Maintenance
4.3 General Inspection & Maintenance
Ground Hog Housing & Chassis Components
Daily:
• Check for obvious loose nuts and bolts.
• Check the wear brush for wear and proper adjust-
ment. Adjust and replace as necessary.
• Check high pressure hoses for deterioration and
wear. Correct problems or replace questionable
components before waterblasting.
• Check hydraulic brake connections for leaks.
Tighten if necessary.
• Check reservoir fluid level at the fill plug in
handle. Proper level is 1 to 1.5” (2.54 to 3.8 cm)
below fill plug threads.
• Inspect all vacuum hoses and fittings weekly for
signs of deterioration, chaffing and leaks. Repair
or replace as necessary.
• Check Control Lever. Make sure it is free and
working properly. Water flow should stop com -
pletely when the lever is fully engaged. Pressure
should immediately drop to zero when the lever
is released.
• Check spray bar speed control valve for proper
operation.
• Thoroughly clean and wipe down the Ground Hog
at the end of each work day.
Periodic Maintenance
• Check wheel casters for excessive wear and the
standoff height. Add shims to adjust if necessary.
Ground Hog Components
A. Handle and Dump Valve Control Lever F. Thru-Shaft Pump Grease Fitting & Pressure Relief Hole
B. Hydraulic Brake Control System Reservoir G. Wear Brush and Wear Brush Clamp
C. Spray Bar Speed Control Valve H. Vacuum Hose Connection
D. Hog Head and Shroud I. Front Caster Wheel Assemblies
E. Swivel Seal and Swivel Nut J. Front Caster Wheel Shims
B
D
E
F
G
H
I
J
A
C