DAYLIGHT SENSOR FUNCTION
Open the daylight sensor by push when remote control is in setting condition.
Settings on this demonstration:
Hold-time: 30min
Stand-by Dim: 10%
Setpoint to light on: 50lux
Stand-by period: +
Setpoint to light off: 300lux
(when the smart photocell sensor open, the stand-by time is only + )
CORRIDOR FUNCTION VS DAYLIGHT SENSOR FUNCTION
1.
ln corridor function, turn on the light MUST by natural light level lower daylight sensor setting and Occupancy . In smart daylight sensor
function, turn on the light by natural light level lower daylight setpoint to light on even if vacancy.
2.
ln corridor function, turn off light by stand-by time finish if vacancy. In smart daylight sensor function, turn off the light by natural light level
higher than daylight setpoint to light off even if occupancy.
3.
ln smart daylight sensor function, natural light level lighter/lower than daylight setpoint to light off/on MUST keep at least 1 minute,that will
turn off/on the light automatically.
ABOUT RESET AND MODE (1,2,3,4)
The remote control comes with 4 Scene MODES which are not default. You may make desired parameters and save as the new MODE(1,2,3,4) to
configure the installed sensors.
RESET: all settings go back to settings of DIP Switch in sensor.
Application
Scene options
Brightness
Detection area
Hold time
Stand-by time
Stand-by dim level
Daylight sensor
Indoor
Mode 1
100%
75%
5min
30min
30%
Indoor
Mode 2
100%
75%
1min
30%
Indoor
Mode 3
100%
75%
5min
30min
30%
30LUX
Outdoor
Mode 4
100%
75%
1min
30%
(30LUX/300LUX)
