INSTALLATION STEPS
1.
Turn power on the driver (lights should be already installed in the driver)
2.
Long press button Zone 1, Zone2 or Zone 3 within 5 seconds after power is turned on. Keep pressing the button zone until the lights are flashing.
3.
When the lights are flashing, the pairing is succesful.
GROUPING
1.
Turn power on the driver (lights should be already installed in the driver)
2.
Long press button Zone 1, Zone2 or Zone 3 within 5 seconds after power is turned on. Keep pressing the button zone until the lights are flashing.
3.
When the lights are flashing, the pairing is succesful.
4.
One driver can be connected to max 2 zones, if you have connected the driver to zone 1 and 2, you can control the driver with lights via zone 1 or
zone 2. When you turn the power on the driver and hold zone 3, the zone 1 will be disconnected. Now zone 3 is connected to the driver.
BRIGHTNESS SETTING
1.
Press the brig icon to add more brightness of the lights
2.
Press the brightness - icon to decrease the brightness of the lights
It is possible to press 77 times on the brightness icons to adjust the brig or -
DISCONNECTING THE WALL PANEL
1.
Disconnecting the zone is possible by connecting a new zone to the driver. Turn the power on the driver and long press the desired zone button
until the lights are flashing.
2.
This means the driver is now connected to a new zone. If you really want to disconnect the driver from one zone, it is needed to connect the
driver to 2 other zones.
Note: The maximum range of the wall panel is 25 meter.
EN
