Hofmann ME1500, Инструкция по установке и эксплуатации

Страница: 9 / 18

9 of 18
6. OPERATING INSTRUCTIONS
1. Raise the lift by pressing the “UP” button on the front face of the Power Pack Motor.
2. Continue raising the lift until the mechanical safety “CLICKS” into position. Always
lower the lift to fully engage the mechanical safety lock.
NOTE: All lifts are equipped with dual safety locking devices, an automatic mechanical
safety bar, and a flow control to protect against hydraulic failure.
3. To disengage the mechanical safety and lower the lift, press the “UP” button on the
Power Pack Motor to raise the lift off of the mechanical safety. Continue raising the
lift until the automatic mechanical safety release device trips.
4. Lower the lift fully to the down position.
5. Roll the vehicle straight back off the lift.
7. RECOMMENDED MAINTENANCE
7.1 DAILY MAINTENANCE
1. Check the general operation of the lift.
2. Check the operation of the automatic mechanical safety lock, both engaging and
disengaging.
3. Check the floor condition in the roller area for cracks and debris.
4. Check the position of the hydraulic hose, ensure that a motorcycle positioned on the
lift or the lift itself will not damage the hose.
5. Check the condition of the electrical cord before plugging the power pack into an
approved 115V power supply.
7.2 MONTHLY MAINTENANCE
1. Check all hydraulic hoses, fittings and cylinder for leaks.
2. Check the level of oil in the power pack reservoir when the lift is in the lowered
position. Add more hydraulic oil (ISO 32) if required.
3. Check and grease all hinge points.