Hoffmann PP2-NCF, Руководство по эксплуатации и техническому обслуживанию

Страница: 19 / 75

Operating and Maintenance Manual
©
HOFFMANN PP2- NCF
• Version 7.267 • 12-2017
19
12. If the HOFFMANN PP2-NCF dovetail routing machine has been
moved, or has been out of service for an extended period of time, all
safety features, guards and safety devices must be checked and
repaired or replaced if necessary before the machine is put back into
operation.
13. Operator must always wear tight fitting clothes without loose straps,
ties, etc. to avoid the danger of entanglement. Long hair must be tied
together and covered with a hair net.
14. Always wear eye and ear protection when operating this equipment!
Do not wear gloves when operating this equipment
– danger of
entanglement!
15. Ensure adequate light conditions on and around the machine, with an
ambient temperature of around 70 degrees Fahrenheit.
16. Keep the floor around the machine free from debris, saw dust or wood
chips, etc. Larger cut-offs and waste material may not be left in the
machine and must be removed manually in compliance with all
applicable safety rules!
17. Tooling Change:
Danger
– cutting tools can injure and cut! Safety gloves are
recommended when handling router bits.
Do not change motor speeds or tooling speeds on router heads.
All tooling (router bits) is to be inspected daily for sharpness and
breakage
– dull and/or defective tooling is to be replaced before
operating the machine. Use only ORIGINAL HOFFMANN ROUTER
BITS!
18. Do not expose this machine to moisture or water and do not expose
this machine to flammable liquids or gases.
19. Route and place all electrical and pneumatic supply lines to avoid the
possibility of creating a trip hazard. All supply lines shall be
adequately protected from accidental mechanical damage.
20. Disconnect the machine from all electrical and pneumatic power
sources when performing any maintenance, repair or set-up
procedures. Follow all applicable OSHA Lock-Out
– Tag-Out
Procedures.