Hoffmann MS35-SF-TP, Руководство по эксплуатации и техническому обслуживанию

Страница: 39 / 114

Operating and Maintenance Manual
HOFFMANN MS35SF-TP Double Miter Saw
• Version 7.148.66 • 06-2017
39
14.2.3 Chip breaker (table insert) change
Router bits are sharp and can cut
– wear safety
gloves when handling router bits.
Note: New chip breakers should be installed
every time router bits are changed or replaced.
Caution:
When changing router bits, chip breakers must
be removed to allow router carriage to travel
unimpeded to bottom home position.
Note: Always place a piece of scrap material on
machine table for initial cut through new chip
breaker. The scrap acts as a backer and
reduces the chance for splitting or tear-outs of
the chip breaker.

With the router carriages underneath the
machine table (in home position), open the
front cover and remove the old chip breaker
(1) by removing the mounting bolts (2).

Install a new chip breaker and tighten all
mounting bolts.
Note: New chip breakers are generally oversized
(wider than final size).
If, during installation, the tips of the new and
uncut chip breakers touch, the machine tables
will not close completely and the machine will
not cycle.
It is then necessary to install one chip breaker
and cut it to size first, then install the second
chip breaker.

After installation of new chip breaker(s), lower
front cover and secure with bolts.

Select “sawing only” with the selector switch
and cut the chip breaker(s) to final width.

Select “set-up’ and rout initial keyways through
new chip breakers
– follow steps outlined
under “router bit installation and adjustments”!