Hoffmann eXess Hand-Held Dovetail Routing Machine
- 4 -
Hoffmann Machine Company, Inc. 1386 Drexel Road Valdese, NC 28690
Phone: (828) 430 - 4510 Fax: (828) 430 - 4620 e-mail: [email protected]
www.Hoffmann-USA.com
7. Technical Data
Number of motors
one
Motor type
115 Volt, 60 Hz, 450 watt
Rotation
CCW
(counter
clockwise)
Revolutions per minute
27,000 rpm (idle)
Collet size
1/4" = 6.35mm
Air
supply none
Max. lateral routing travel
2 3/8”
Max. material thickness
not limited
Max. material width
not limited
Dovetail Key sizes
W-1, W-2, W-3 - up to 2 3/8”" length maximum
Operating noise
75.3 dB (A)
Machine dimensions
13” long, 7” wide, 9” high
Weight:
7.25
lbs.
8. Machine Installation
8.1 Unpacking – Inspection
Upon receipt, check the machine and shipping container for any damage. Report any transportation damage to the
delivering carrier and indicate it on the bill of lading. Request an immediate inspection for assessment of damage.
Claim should then be entered with the carrier. The carrier is solely responsible for any loss or damage during transit.
8.2 Placement
After unpacking, select a suitable location with enough room around the machine for safe and unobstructed workflow,
cleaning and maintenance.
It is best to place the machine on a sturdy workbench of comfortable height.
8.3 Cleaning
Clean the machine and remove the applied rust preventive coating with a cotton rag and thin oil (WD-40 or similar). Be
careful when using liquids containing silicones – the finishing process of your material could later be impaired.
Never use thinner or solvents to clean machine, damage could result.
8.4 Electric Connection
The machine power cord is equipped with a standard 115 Volt plug. Be sure the receptacle is in good working
condition. Also, be sure the power cord does not obstruct any walkways. If applicable, use only three wire extension
cords of the proper size. Replace damaged or worn power cords immediately.
N
EVER ATTEMPT TO REPAIR A DAMAGED POWER CORD
.
