Hoffman nvent Genesis HB16, Инструкция по эксплуатации, Страница: 8 / 18

87976428
- 7 -
MOUNTING ON TOP OF THE ENCLOSURE
1. Make sure the enclosure design is capable of supporting the air conditioners weight. For
interfacing air “IN” and “OUT” openings, refer to Figure 4. Also refer to Dimensional Drawings on
page 11.
2. To avoid cross-threading mounting inserts, start bolts by hand before tightening with a wrench or
ratchet driver.
3. To protect the integrity of the closed-loop design (see PRINCIPLES OF OPERATION), adhesive
backed gasket tape is provided (shipped loose) for sealing around the enclosures cutout
openings. The gasket may be cut to length and either adhered to the enclosure or to the air
conditioner as shown in Figure 5.
4. A .5 inch (13 mm) inside diameter drain tube exists on the side of the air conditioner and must
be routed over the side. A pressure r������������ ovided to assist in venting any air
blockage that may prevent proper drainage. A copper “P” trap has also been included in the
system and must be properly primed and installed to prevent counter air ��into the drain
system. The drain outlet must not be submerged nor any portion of the drain system elevated
above the exit point of the air conditioner or overlapping of the condensate pan may occur.
Mounted on Top of Enclosure
Figure 3
Cutout Dimensions for Top Surface Mounting
Dashed Lines Repersent Air Conditioner
Figure 4
Gasket Installation
Figure 5
Outside of Enclosure Through Enclosure
Drain System
Figure 6
C-NET INDUSTRIAL LTD. | +44(0)121 544 8608 | INFO@CNET-IS.CO.UK | WWW.CNET-IS.CO.UK