HOFFEN NB-9561, Инструкция по эксплуатации

Страница: 24 / 28

3
24
2. Insert the foodstuffs intended to be mixed/blended/stirred into the bottle,
making sure they do not exceed the capacity marked on the bottle with Max.
The foodstuffs should be laid loosely — do not stuff them in the bottle.
3. If the prepared cocktail or smoothie requires adding some liquid — add it so
that the content does not exceed the Max level.
4. The cap with crossed blades should be used for smoothie, blending, mixing,
and cam with simple blades for grinding dry and hard products.
5. Slide the bottle with the blade (crossed or simple) cap screwed on into the
opening on the top of the blender drive unit (part of the blender base).
6. When assembling the two components, make sure the three tabs on the
bottle enter into the openings in the device housing. Then, rotate the bottle
clockwise, pressing it slightly towards the drive unit inside.
7.3 Removing the bottle from the drive unit.
1. Stop blending by pressing the on/off switch.
2. Disconnect the plug from the mains (unplug it from the outlet).
3. Rotate the bottle counter-clockwise.
4. Remove the bottle with the blade cap from the drive unit on the blender base.
5. Place the bottle on its base.
6. Now you may remove the blade cap and twist on one of the carrying lids.
7.4 Operation / blending
1. Install the bottle in accordance with the description in point 7.2 Bottle
installation .
2. Before turning on the device, make sure it is standing firmly on a flat and
stable base, such as a table.
3. Next, press the on/off switch . The device will operate as long as the on/
off switch is gently pressed (recommended for the pulsating mode). If you
press the on/off switch more strongly, the device will enter the continuous
operation mode.
4. To switch the device off, press the on/off switch again, or — in the pulsating
mode — release the pressure on the key.
5. As the blender blades are operating, observe the foodstuffs in the bottle, so
that you obtain the required effect of blending, shredding, mixing, etc.
6. It is recommended not to exceed 1 minute of continuous operation.
7. If the blender blades become jammed, immediately turn the device off,
disconnect it from the mains, and remove the bottle from the drive unit on
the housing. Remove the jam reason in the bottle.
BLADES :
a) Simple - for grinding hard and dry products
b) Crossed - preparation of cocktail, mixing, mixing.
Caution! The device will not turn on if the bottle is installed incorrectly.
Caution! Use the carrying lids to carry the blended or mixed products. Do not