HOFFEN CSI-2111, Инструкция по эксплуатации

Страница: 25 / 30

25
closed padlock position .
3 . Set the steam regulator to the (no steam) position .
4 . Connect the power cord plug to a grounded electrical outlet .
5 . Set the required ironing temperature with the indicator on the iron casing by turning
the temperature control knob clockwise to the desired position .
6 . The light indicator of the iron heating process will turn on .
7 . When it goes off, it means that the iron has reached the desired temperature .
7.6 Sprinkler function
You can use this function to remove stubborn creases .
1 . Check if there is water in the tank, if not - go to section 7.2 Filling the water tank .
2 . Press the spray button repeatedly to moisten the fabric being ironed . The water will
come out of the spray nozzle in the front part of the iron .
7.7 Steam burst function
It is useful for removing creases from hanging clothes, curtains, etc . You can also use
this function when dry ironing .
ATTENTION! The steam must not be directed at people!
1 . Check if there is enough water in the tank, if not go to section 7.2 Filling the water
tank.
2 . Place the iron in an upright position .
3 . The temperature control knob should be set to at least
or MAX .
4 . Connect the power cord plug to a grounded electrical outlet .
5 . The light indicator of the iron heating process will turn on and it will turn off when the
iron has reached the desired temperature .
6 . Press the steam burst button while pointing the soleplate towards the fabric .
7.8 Steam ironing
1 . Check if there is enough water in the water tank, if not, go to section 7.2 Filling the
water tank.
2 . Place the iron in an upright position .
3 . The temperature on the temperature control knob should be set to at least
or
.
4 . Set the steam boost setting to the or position .
5 . Connect the power cord plug to a grounded electrical outlet .
6 . The light indicator of the iron heating process will turn on and it will go out when the
iron has reached the desired temperature .
7 . Steam will only come out of the iron in a horizontal position .
8 .
After you finish ironing with steam, set the steam boost setting to the (no
steam) position .