140 58th St.
FN-600ULX
Power Supply/Charger
Installation Guide
Altronix Co rp.
Rev. 120104
Страница 1: ...140 58th St FN 600ULX Power Supply Charger Installation Guide Altronix Corp Rev 120104 ...
Страница 2: ...steners Place the enclosure s upper keyholes over the two upper screws Install the two lower screws and make sure to tighten all screws Enclosure Dimensions pg 4 2 The power supply is pre wired to the ground chassis Connect main incoming ground to the provided green grounding conductor lead Connect unswitched AC power 115VAC 60 Hz to the terminals marked L N Fig 1 pg 4 Use 14 AWG or larger for all...
Страница 3: ...AC or brownout fail is reported within 1 minute of the event To delay reporting for up to 6 hrs cut AC delay jumper and reset power to unit Bat Fail NC C NO Indicates low battery condition e g connect to alarm panel Relay normally energized when DC power is present Contact rating 1 amp 28VDC Low battery conditions will report approximately 21VDC 24VDC output setting or approximately 10 5VDC 12VDC ...
Страница 4: ...on power limited 12VDC Rechargeable Battery optional CAUTION Optionalrechargeablestand by batteries must match the power supply output voltage setting Keeppower limitedwiringseparatefromnonpower limited Use minimum 0 25 spacing Enclosure Dimensions H x W x D 13 5 x 13 x 3 25 342 9mm x 330 2mm x 82 55mm The door is included 12 5 1 20 31mm 1 40 36mm 5 10 130mm 5 10 130mm 3 25 83mm 25mm 267mm 25mm Ho...