HOBO Pendant Temperature Data Logger (UA-001-xx) Manual
1-800-LOGGERS (564-4377) • 508-759-9500
www.onsetcomp.com/support/contact
© 2011–2018 Onset Computer Corporation. All rights reserved. Onset, HOBO, Pendant, and HOBOware are trademarks
or registered trademarks of Onset Computer Corporation. All other trademarks are the property of their respective
companies.
Patent # 6,826,664
9531-O
7.
Return the circuit board and label to the case, carefully
aligning the circuit board with the grooves in the case so
that the battery faces the ridged side of the case.
8.
Remove the O-ring from the end cap. Use the thumb and
finger of one hand to hold the cap from the top and
bottom, and use the thumb and fingers on your other hand
to slide the O-ring to form a loop as shown. Use this loop to
roll the O-ring off the cap.
9.
Inspect the O-ring for cracks or cuts and replace it if any are
detected (the O-ring is included in the Pendant replacement
parts kit, UA-PARTSKIT).
10.
Using your fingers (not cloth or paper), spread a small dot of
silicone-based grease on the O-ring, just enough to moisten
it all the way around and making sure that the entire O-ring
surface is completely coated with grease. As you work the
grease into the O-ring, make sure there is no grit or debris
on the O-ring.
11.
Place the O-ring back on the end cap, making sure it is fully
seated and level in the groove. Make sure the O-ring is not
pinched or twisted and that no dirt, lint, hair, or any debris
is trapped on the O-ring. This is necessary to maintain a
waterproof seal.
12.
Very slightly grease the inside rim of the case, especially
around the screw holes with the silicone grease, just
enough to moisten the inside edges without touching any
circuitry. Make sure that there is no excess lubricant that
could get onto the logger electronics or label. Make sure
there is no debris on this surface.
13.
Check that the desiccant pack is tucked into the cap.
14.
Carefully push the end cap into the lubricated case until the
screw holes are aligned. Visually check that the O-ring forms
a uniform seal all around.
15.
Re-fasten the screws. Tighten the screws until you feel
them hit the bottom of the screw holes, but not so tight
that they distort the clear housing.
WARNING:
Do not cut open, incinerate, heat above
85°C (185°F), or recharge the lithium battery. The battery
may explode if the logger is exposed to extreme heat or
conditions that could damage or destroy the battery case. Do
not dispose of the logger or battery in fire. Do not expose the
contents of the battery to water. Dispose of the battery
according to local regulations for lithium batteries.
