HobbyZone Champ, Инструкция по эксплуатации

Страница: 10 / 14

18 19
Replacing the Propeller
You may need to replace the propeller in the event of a crash .
If you have access to hemostats, grip the prop shaft
between the spinner and fuselage front and turn propeller
counterclockwise to remove propeller . If you don’t have
hemostats, continue below .
1 . Have an adult carefully use a hobby knife and cut through
the clear tape on the side of the fuselage as well as across
the top seem of fuselage . See Step 1 of Replacing the Prop
Shaft .
2 . Carefully remove fuselage top and side to gain access to
the inside .
3 . Grab the spur gear (as shown) and turn propeller
counterclockwise until it releases from the prop shaft .
4 . Thread the new 130mm x 70mm prop and spinner
clock wise onto the gearbox shaft .
5 . Carefully place fuselage parts back and re-tape with
clear tape .
Replacing the Prop Shaft
You may need to replace the prop shaft in the gearbox should it
become damaged . To replace the prop shaft:
1 . To remove prop shaft, open the fuselage by cutting through
the clear tape on one side of the fuselage . Also cut the tape
across the fuselage in front of the rudder .
2 . Gently grasp the white nylon nut located at the back of the
prop shaft to prevent it from turning .
3 . While holding the nylon nut, rotate the spur gear in a
clockwise direction . The prop shaft will thread out of the nut .
4 . Gently pull on the spur gear and the prop shaft will slide out
of the gearbox . You may need to cut away a small portion
of foam to allow the spur gear to slide forward out of the
gearbox .
5 . Remove the propeller from the old prop shaft, then
thread the 130mm x 70mm prop and spinner on to the
new prop shaft by holding the spur gear and turning the
prop clockwise .
6 . Slide the new prop shaft back into the gearbox .