Note the two CF locator pins to keep the incidence of the wing as designed. To install these,
first test fit them in each of the holes in both the fuselage and wings. This is necessary as
during painting and transport these holes can effectively shrink. If they are too small, drill out
to the diameter required.
Next, glue these to the fuselage (or to the main wings, the choice is yours) using 5 minute
epoxy or strong CA. Wait for this glue to dry and apply 30 minute epoxy between the main
wings and fuselage. Apply glue and tape or clamp both surfaces and support using blocks if
necessary. It is recommended that you glue both wings at the same time.
Step 6: Horizontal stab attachment
Repeat the same procedure as above for the horizontal stabs. Note that a symmetrical airfoil is
used for these so there is no left wing or right wing as such, either orientation is correct.
Step 7: Elevator servo instillation
For the elevators, begin by taking two high quality 5g micro servos. Screw these side by side
as shown. Drill pilot holes in the wooden blocks (provided) and make sure that the combined
width of the servos does not exceed 24mm.
