9
4.Hold the bracket over the rear end
of the fuselage and drill holes
through the front and rear mounting
holes. Screw the bracket in place
with
the
two
washer
head
self-tapping screws provider. Push
the wheel collar up under the bracket
and tighten the setscrew to hold it in
place.
5.Take the Rudder control pull-pull
cable, insert it into the tube in the
fuselage, perforate at the end of the
tube, take the cable out of the
fuselage, and then drill through the
hole of the plastic clevis, clamp the
cable with a copper tube using pliers.
Attach the clevis end of the pushrod to the hole of the plastic control
horn.
6. Take out the Elevator pushrod. Fit
you miniature servos in the elevator
servo mounts and enlarges the
opening if necessary. Pull the servo
wire through the fuselage and out he
hole in the middle of fuselage that
can be linked with receiver. You will
need to add an extension to the end
of your rudder and elevator servo
wires. Locate the rudder and
elevator pushrods and slip the “Z”
bend through the hole in the servo
arm. Attach the clevis end of the
pushrod to the hole of the plastic
control horn.
