HobbyKing Assault 100, Инструкция по эксплуатации

Страница: 12 / 22

10
RF MODULE
Internal power supply switch
Mode indicator light : F/ J/ other
( )
Mode selector button
Signal indicator light
(
Red : signal disable / charging ;
Green: signal enable / low power )
1. RF MODULE CHART
2. Parameters
Sealed battery Specification: 3.7V Li-Po battery 150mAh
Operating voltage: 5 ~ 12V.DC
Operating Current: ≤ 100 mA
Operating frequency: 2402 MHZ ~ 2477 MHZ
Spread Spectrum mode: FHSS
Number of frequency channels: 20
Hopping Rate: 240 Jump/s
3.
Charging operation
First put the internal power supply switch to OFF position, no LED lights on RF Module bright this
time, then connect RF Module to a computer (or the other power supplier equipment) using USB
wire, this time, Signal indicator light starts to flash and Mode indicator light shows charging status:
red means charging,turning to green means charging is over.
4. Normal operation
Function
3.Charging protection and Low voltage alarm function.
1.Built in battery supply with charge protection and low voltage alarm.
2.Supports most mainstream radios.
RF Module instruction
Also use to indicate charging status
1. If the radio supplies power to the module, switch the internal power supply switch to the
OFF position. Connect the module to the radio via the included signal cables.
2. If no power is supplied by the radio, switch the internal power supply switch to the ON
position. Connect the module to the radio via the included signal cables.
3. Under normal circumstances, the LEDs are green, if they are red, check to see if the signal
cable is properly connected. Check also that the radio is operating under PPM output.
Press the button on the module to cycle through different radios- the status indicator will be
green with Futaba radios, red with JR radios and off with Walkera radios.