o
The servo reversing menu (REV.NORM) should be visible. If not press scroll until it is.
o
Once you reach the reversing menu, use the channel key to scroll through each channel
and set them to the following.
§
AIL=REV
§
ELE=NORM
§
RUD=NORM
§
GER=NORM
§
PIT=NORM
§
THR=NORM
o
Press scroll until TRV ADJ. is visible.
o
Press scroll and select the GER channel.
o
Place the Aileron DR switch to 0. Use the decrease button to set +45%.
o
Press scroll until HLD is visible.
o
Use decrease and set to -1%.
o
Press scroll until you reach the Pitch Curve Menu. Use the channel button to select PLN,
P2N and PHN and set the following values using increase and decrease.
§
PLN=35%
§
P2N=50%
§
PHN=100%
o
Press scroll to advance to the next Pitch Curve Menu. Use the channel button select PLS,
P2S and PHS and set the following values using increase and decrease.
§
PLS=0%
§
P2S=50%
§
PHS=100%
o
Press scroll to advance to the next Pitch Curve Menu. Use the channel button select PLH,
P2H and PHH and set the following values using increase and decrease.
§
PLH=0%
§
P2H=50%
§
PHH=100%
o
Press scroll to advance to the Throttle Curve Menu. Use the channel button select TLN,
T2N and THN and set the following values using increase and decrease.
§
TLN=0%
§
T2N=65%
§
THN=100%
o
Press scroll to advance to the Throttel Curve Menu. Use the channel button select TLS,
T2S and THS and set the following values using increase and decrease.
§
TLS=100%
§
T2S=80%
§
THS=100%
o
Press scroll until your reach the CCPM Menu. "mix CCP OF" is displayed.
o
Press increase to enable CCPM. Display will change from CCP OF to CP2.
o
Use the channel button to select CP2, CP3 and CP6. All three should have a value of 60%
by default. Use increase and decrease to set the following values.
§
CP2 = 30% (Approximately 6 degrees of total cyclic travel [ -, + 3 degrees left and
right] )
§
CP3 = 30% (Approximately 6 degrees of total cyclic travel [ -, + 3 degrees forward
and aft] )
§
CP6 = 60%
§
CP2 and CP3 adjusts the cyclic travel of your swashplate (forward, back,
left, right)
§
CP6 adjust the total up and down travel of the swashplate (pitch of rotor
blades)
§
CP2 and CP3 can be increased if you are experienced or after you
become comfortable with your heli. The transmitters default setting of
60% will give you about 12 degrees total cyclic travel, [ -, + 6
degrees]. At this high setting the mechanics are very near binding. In