6
90
90
The horizontal stabilizer into the fuselage glue arround the edge
with CA glue .check the perpendicularity as shown .
Put the elevator horn onto the “Z” wire as shown .mark the position
for slot .Cut the slot 6mm deep.
Glue the elevator horn into the elevator with CA glue as shown.
Glue vertical fin on the fuselage using CA glue .Check the
perpendicularity and alignment as shown.
Bend the elevator as shown . put the rudder horn onto the “Z”wire
as shown .mark the position for slot .cut the slot 6mm deep.glue the
horn into the rudder with CA glue as shown .
Switch on the RC set. Put the control surfaces to the neutral as
shown . Tighten the connector screws .cut the pushrods as shown .
Put
control
surfaces
into
neutral
Glue the wing panels together using CA glue .
40mm
40mm
800mm
Cut the slot in the wing using sharp knife .the slot must be 3mm
deep and 800mm length.
Press the wire into slot in the wing .
