Hobbies & Helis Gas-Her, Инструкция по эксплуатации

Страница: 95 / 104

most setups, but a powerful motor or a light helicopter might need more. For rpm
adjustment during anything other than full stick deflection you should use the throttle.
A short recap, adjust throttle to adjust rpm during anything other than full collective. At
full collective adjust the pitch. See the Throttle table for general setup.
These are guidelines and will get you going but might not be 100% accurate in regards
to all helicopters. Especially the throttle curve table should be considered as initial
guidelines. As mentioned before it's greatly affected by your equipment. As you become
more familiar and proficient with your helicopter you can change the pitch and throttle
curves to your flying style.
8-7 CANOPY MOUNTING
No. Bag# Description Qty
1 Helicopter 1
2 In box Canopy 1
3 8 Canopy Grommet 4
4 HB M3x10 Cap Head Bolt 4
5 HB M3x13 Flat Washer 4
Note: Different canopy may be shown.
•
Use the template comes in the kit to cut the bottom of the Canopy.
•
Put the Canopy on the helicopter, mark the right positions for 4
holes, and then drill four 5.5mm holes.
•
Install the Canopy Grommets on the Canopy.
•
Secure the Canopy by four M3x13 Flat Washers and four M3x10
Cap Head Bolts.
Page 95 of 104