Quick Field Charger MkII uses solid-state and fused overload circuitries
to protect against potential damage which could be caused by short-
circuit or reverse polarity conditions and provides a backup safety timer.
Reverse Input Polarity:
If input power to the charger is connected
in reverse polarity, the charger will be protected from damage but will
not function. Re-check all input connections and the power source to
ensure the proper power and polarities are observed.
Battery Condition Pre-Check:
Any time a command is given to
begin charging a battery, the charger will check the condition of the
battery and determine if it is suitable for charging. If an error exists
on either output, the respective LED will flash red and green
alternately, accompanied by audible tones to note the error. This can
occur when a battery is connected to the output in reverse polarity,
or if the charger does not recognize a solid electrical connection to
the battery on the output. The charger will be protected from
damage in either case. Make sure the battery is solidly connected to
the output in proper polarity.
Current Overload:
If for some reason a short circuit condition exists
on the input or output, the 7.5A spade (auto) fuse located on the left
side of the charger might blow. In this case, make sure the charger’s
power switch is in the “off” position. Remove and inspect the fuse. If
the fuse is blown, replace with another fuse of the exact same rating.
Backup Safety Timer:
If for some reason the charger does not
recognize that the battery has reached full charge, a backup safety
timer will automatically stop charge to prevent damage from
occurring to the pack. The safety time is 2 hours for NiCd and NiMH
batteries, and 3 hours for LiPo/Li-Ion batteries.
PROBLEM: Charger doesn’t recognize battery.
CAUSES AND CURES:
1) Battery may be connected backwards. Connect battery leads properly.
2) Faulty connection or wiring. Correct or replace charge lead.
3) Defective cell in the pack. Replace battery pack or cell.
PROBLEM: Does not automatically terminate peak charge of NiCd
or NiMH batteries after 2 hours, or terminate quick charge of LiPo/Li-
ion batteries after 3 hours.
CAUSE AND CURE: Internal problem with charger. Disconnect
battery immediately and contact
Hobby Services
for further details.
PROBLEM: Battery voltage low after charge (below 1.2V per cell for
NiCd and NiMH batteries, or below 3.6V for LiPo/Li-Ion batteries).
CAUSES AND CURES:
1) Charge rate setting too low. See
“Charging Batteries.”
2) Battery connected in reverse. Connect battery leads properly.
3) Defective battery, needs to be replaced.
PROBLEM: LEDs and controls do not function properly.
CAUSE AND CURES: Battery possibly connected backwards. Connect
battery leads properly, or contact
Hobby Services
for further details.
Hobbico offers a variety of charge leads to match any radio system
you may have. These items may be purchased through your local
hobby shop.
Part #
Item Description
HCAP0101
Futaba J Tx and Rx charge leads, except 9VAP
HCAP0102
Futaba J Tx and Rx charge leads, 9VAP only
HCAP0104
Airtronics/Sanwa Tx and Rx charge leads
HCAP0105
JR Tx and Rx charge leads
HCAP0106
Hitec Tx and Rx charge leads
HCAP0108
Charge leads, banana plugs to alligator clips
HCAP0110
9V-style Tx connector, Futaba-J Rx charge lead
HCAP0310
Banana Plugs (3 pair)
HCAP0320
Heavy Duty Banana Plugs (2 pair)
Hobbico warrants this product to be free from defects in materials
and workmanship for a period of two (2) years from the date of
purchase. During that period, Hobbico will, at its option, repair or
replace without service charge any product deemed defective due to
those causes. You will be required to provide proof of purchase
(invoice or receipt). This warranty does not cover damage caused by
abuse, misuse, alteration or accident. If there is damage stemming
from these causes within the stated warranty period, Hobbico will, at
its option, repair or replace it for a service charge not greater than
50% of its then current retail list price. Be sure to include your
daytime telephone number in case we need to contact you about
your repair. This warranty gives you specific rights. You may also
have other rights, which vary from state to state.
For service on your Hobbico product, warranty or non-warranty,
send it post-paid and insured to:
HOBBY SERVICES
3002 N. Apollo Dr., Suite #1
Champaign, IL 61822
(217) 398-0007
*For warranty and service information if purchased outside the USA or
Canada, see the additional warranty information insert (if applicable)
or ask your retailer for more information.
www.hobbico.com
Made in Korea ENTIRE CONTENTS © Copyright 2005 HCAZ3014 for HCAP0290 V1.2
2-YEAR LIMITED WARRANTY
(
U.S.A. & CANADA ONLY*
)
CHARGE LEADS
TROUBLESHOOTING GUIDE
