battery to the speed control and fit the battery in place with the
battery cover.
❏
8. Install the 8 AA batteries in the transmitter. Switch on the
transmitter and check the LED’s on the front of the transmitter.
Like a traffic light, green means “GO!” However, if the red LED
is flashing, you need to install fresh batteries.
❏
9. Turn the transmitter and receiver on. Center the trims on the
radio. Fit the servo arms back onto the servos and secure them
with the screws. Turn the receiver off then the transmitter.
❏
1. Secure the stabilizer to the fuselage with two medium
screws. Be careful to not overtighten the screws and crush the
stabilizer.
❏
2. Insert the fin into the fin slot in the stab and fin holder. Use
a medium screw, inserted through the left side, to secure the fin
to the fin holder. Again, be careful to not overtighten the screws
and crush the stabilizer
❏
3. Attach both rudder and elevator clevises to the outer holes
of the rudder and elevator control horns.
❏
1. Insert the wire landing gear into the slot in the bottom of
the fuse.
INSTALL THE LANDING GEAR
ASSEMBLE THE TAIL
7
