Hobart CHF 45, Инструкция по установке и эксплуатации, Страница: 17 / 29

OPERATING AND MAINTENANCE
Page 16
5. Successive Cycles
Check the washing solution
. If this is too dirty, or the filters are clogged by residue from previous
washes:
•
Empty the tank as described in the “Emptying the Machine” paragraph.
•
Clean the machine as indicated in the “Maintenance” paragraph.
•
Replace the washing solution.
Follow the instructions given for the first cycle from point 6 “Prepare the basket of dishes to be
washed” until the end.
6. Infinite cycle
To operate in the infinite cycle modem use the cycle selection button [3] to select the infinite cycle
option (LED [9] lit), then press start [2].
The machine continues to wash until start [2] is pressed again, which will activate the rinse cycle.
When rinsing has been completed the machine returns to standby mode.
7. Emptying the machine
I. Machines without drain pumps
Switch the machine off using the switch on the line [5].
Remove the plug for the overfull level and wait until the tank is completely empty
before cleaning, following the steps described in paragraph 7 “Maintenance”.
The machine must be switched off whenever the overfull plug is removed.
II. Machines with a drain pump
To make the machine drain:
I. Press the cycle selection button [3] until LED [11] switches on.
II. Remove the over full plug.
III. Close the door.
IV. Press the cycle start button [2]. The machine switches off when the drain cycle has been
completed.
8. Before stopping for the day
•
Clean the machine as described in the “Maintenance” paragraph.
•
The door has a balanced intermediate position (door ajar). It is
advisable to leave the door in this position on stopping work to
avoid the development of foul odours inside the washing tank.
EF 40